This section provides the sFlow show command descriptions.
The commands described in this section apply to the 7950 XRS, 7750 SR-12e, and 7750 SR-7/12 platforms.
The command outputs in this section are examples only; actual displays may differ depending on supported functionality and user configuration.
This command displays the primary and backup receiver statistics, the mapping configuration and a summary of how many ports and SAPs have sFlow enabled.
Show sFlow Output Fields
Table 86 describes the show sflow output fields.
Label | Description |
sFlow Status | |
Receiver | Displays the configured name for the sFlow receiver. |
Max Data Size | The configured maximum data size for sFlow UDP packets. |
IP Addr Primary | The primary IP address and destination port for sFlow receiver. |
IP Addr Backup | The backup IP address and destination port for sFlow receiver. |
Packets Sent | The number of packets sent successfully to the primary or backup receiver destination, since the destination was configured, CPM card HA switchover, or system reboot. |
Packet Errors | The number of packets that could not be sent to the primary or backup receiver destination because of an error, since the destination was configured, CPM card HA switchover, or system reboot. An example of an error is destination IP not reachable. |
Last Packet Sent | Displays the date and time of the last packet sent. |
Counter Pollers | |
Port | Displays the port on which sFlow is enabled. |
No. of SAPs | The number of SAPs on the port with sFlow enabled. |
No. of sFlow counter pollers | The number of sFlow counter pollers. |
Counter Mappings | |
Direction | Displays the direction of traffic (ingress or egress) the map entry applies to. |
Policer/Queue | Displays the policer or queue instance being mapped by sFlow map. |
Traffic type | Displays the type of sFlow traffic statistics (unicast, multicast or broadcast) that the policer/queue maps to. |
No. of sFlow counter mappings | The number of entries in the sFlow ingress and egress counter map. |